Royce Cb mic question
- surveyor1
- NEW DUCK
- Posts: 3
- Joined: May 10th, 2011, 5:21 pm
- Real Name: Roy
Royce Cb mic question
I just bought a AM/FM/CB 23 channel Radio, yep the one on E-bay, with a missing 6 pin mic, Could someone tell me where to find an original mic for this and/or what would you recomend I get, to mabey upgrade.
Thanks
Thanks
-
Bombero Verified
- Site Admin
- Posts: 5,811
- Joined: March 7th, 2009, 10:35 pm
- Handle: Boogieman
- Real Name: Bombero
- Antenna: 2ft Wire hanger
- Radio: RCI 2950 Mirage
- Contact:
Re: Royce Cb mic question
Hey Roy..
Welcome to CBRT....the #1 CB site on the internet.
You can wire just about any microphone to the Royce CB. Check CBTricks.com for the mic wiring diagram.
Check craigslist in your area for used mic's and CBRT sponsors at the bottom of this page.
Good Luck
Bombero
Welcome to CBRT....the #1 CB site on the internet.
You can wire just about any microphone to the Royce CB. Check CBTricks.com for the mic wiring diagram.
Check craigslist in your area for used mic's and CBRT sponsors at the bottom of this page.
Good Luck
Bombero
Official Moderator - CBRT Complaints Department
We encourage all users to support our sponsors. We believe our sponsors are the best out there.
Be sure to tell them you saw their name on CBRadioTalk.
Support our fine sponsors!
We encourage all users to support our sponsors. We believe our sponsors are the best out there.
Be sure to tell them you saw their name on CBRadioTalk.
Support our fine sponsors!
383 Boogieman
- surveyor1
- NEW DUCK
- Posts: 3
- Joined: May 10th, 2011, 5:21 pm
- Real Name: Roy
Re: Royce Cb mic question
Ok, Thanks Bombero
- surveyor1
- NEW DUCK
- Posts: 3
- Joined: May 10th, 2011, 5:21 pm
- Real Name: Roy
Re: Royce Cb mic question
I was advised not to hook up a power mic to this radio, it should be stong and sound good enough. What advice would someone give me while looking for a mic for this radio, Also does anyone have a mic that would fit. Its a 6 pin 5 round and 1 in the center with a notch above. A snap in kind not screw. Thanks