2510 stock mic to 5 pin cobra

[hank_612]

I need the color code to rewire a 5 pin uniden 2510 stock mike to work on a teaberry stalker xx.

[MDYoungblood]

Okay , going to give it a shot ,
the stock 2510 wiring is 1-Audio, 2-Shield, 3-Transmit, 4-Channel Up, 5-Channel Down, I don't know the original colors of those wires. When you take the plug apart note the location and wire colors. Post them so we have them as a reference later.
To wire it to the Teaberry, here is the wiring for it, 1- Audio, 2- Shield, 3- Receive, 4- Sw Com, 5- Transmit. I am not sure if the 2510 mic will work , need to jump a ground to pin 4 from 2 and move the pin 3 to pin 5. See if the 2510 mic has an extra wire in it , check to see if it is grounded on receive and put it on pin 3.
The Turner you talked about on the "ShoutBox" is wired , 1- White, 2- Shield, 3- Black, 4- Red, 5- Blue, Yellow NC.
Hope this works,

3's

Greg

[TheCBDoctor]

I need the color code to rewire a 5 pin uniden 2510 stock mike to work on a teaberry stalker xx.

Hi hank_612,

The HR-2510 Mic will not work if you need 4 wires. Only three of the wires on the 2510 Mic will be of any use. The other two are used for the UP-DOWN control on the MIc. It will work on Export radios due to the electronic switching and relay radios (Not recommended for tube radios). These radios do not need a receive wire so you will only need the ground wire, the Tx wire and the audio wire. If the Teaberry needs a receive wire, which I believe it does, then the HR-2510 stock mic will not work because you will not hear the receive audio.

Respectfully,

[hank_612]

I need the color code to rewire a 5 pin uniden 2510 stock mike to work on a teaberry stalker xx.

Hi hank_612,

The HR-2510 Mic will not work if you need 4 wires. Only three of the wires on the 2510 Mic will be of any use. The other two are used for the UP-DOWN control on the MIc. It will work on Export radios due to the electronic switching and relay radios (Not recommended for tube radios). These radios do not need a receive wire so you will only need the ground wire, the Tx wire and the audio wire. If the Teaberry needs a receive wire, which I believe it does, then the HR-2510 stock mic will not work because you will not hear the receive audio.

Respectfully,

I sent you an email regarding this radio.