Schematics

[Holiday616]

I'm looking for a schematic for a Galixy DX 2517. The cbtricks.com site doesn't have the one for my board 690011D. Any ideas? Thanks

[MDYoungblood]

The same board is used in the Galaxy DX95T2 , look at that on CB Tricks.

3's

Greg

[Holiday616]

Thanks for the information! It is greatly appreciated.
Holiday

[Holiday616]

Greg, I checked it out. The 95T2 and every other one I checked havery a 10 pin IC8, the one I have has a 5 pin. Any other thoughts? Holiday

[MDYoungblood]

Greg, I checked it out. The 95T2 and every other one I checked havery a 10 pin IC8, the one I have has a 5 pin. Any other thoughts? Holiday

IC-8, isn't that the audio chip? I don't know what to say, the manufacturer's do a design change all the time, you must have a newer version.

3's

Greg

[Holiday616]

I need to replace the driver and the finals. The ones in the radio. Look to have already been replaced before. There is no marking on them. So I'm trying to make sure I install the right ones. Holiday

[MDYoungblood]

Well that is an easy question to answer. the older models used a 2SC2166 driver and 2x 2SC2312 finals, the mosfet version has 3x IRF520, one for the driver and 2 for the finals. A word to the wise, don't think cheap, those transistors are usually fakes.

3's

Greg

[Holiday616]

Thanks Greg!! I appreciate the back and forth follow up! Chuck