new version magnum 1 bias voltage

[Deleted User 30864]

hello everyone. I am trying to tune up a magnum one and having trouble setting the bias.
does anyone know the average settings for the driver and 2 finals. i have installed some genuine ON semiconductor FQP13N10.
i know these are not as robust as say a IRF520 or ERF2030+ but i have a great match on my antenna so i am not worried.
i am also aware that fqp13n10s do not need as much bias voltage as those other fets i mentioned.

any input would be great. thank you.

[MDYoungblood]

Hmm, I would bet the radio has an RCI board in it so the originals could have been 520's. Since you have changed them to FQP13N10, I wouldn't go over 10mA on the driver and 50ma (both) on the finals, stay on the lesser side of 50mA and adjust for best performance. JMO.

3's

Greg

[sonoma]

see if this info will help you on the alignment of the new radio. this info it for the ones built after 2016. just lower the bias a little from the original version as MDY mentioned.

[Please login or register to view this link]

[Deleted User 30864]

Hey I appreciate the information everyone. Thing is. I’m having trouble getting readings using a multimeter in MA mode and probing the jumper pins. I have read the mag 1 bias instructions found on net. But I am able to get readings by grounding one lead and the other at the gate of the fets. So going by voltage on the gate. Can it not be done like this?
Yes originals fets were IOR 520s
I do not believe it is a rci main pcb. It’s more like a Lincoln v2+ or the Stryker radios. Most of it is surface mount.

[Deleted User 30864]

so i have been at this for a few days now. i am using a klein tools mm600 multimeter. i set it to ma and connect positive lead to the ma section on meter. removed both header pins at W3 and W4. set the radio to LSB with mic gain off. key up and probe the 2 pins with meter and nothing. i can not get any readings what so ever. same for both at w3 and w4.
can someone give me some advice please.
or does anyone know what the volts should be at the gate of mosfets for driver and finals. NOT milliamps

[13el121]

I have a Maxlog 8800 v06 converted to Fqp13n10. Gate voltage set to 3,7v for driver and 3,6v for finals. Works, but only 5w more than 520s. Not worth doing the job imo.

[MDYoungblood]

Guess he got his answer and then no longer wanted to be part of the forum, "Que Sera, Sera". I am leaving this topic in place, it may help others with this problem.

3's

Greg