Browning Mark IV-Plate Tuning screw

Forum rules

4 posts • Page 1 of 1

RodinKy: Donor; Posts: 131; Joined: January 11th, 2017, 1:27 pm; Real Name: Rod Eagan; Antenna: IMAX 2000/Maco Comet; Radio: DX2517 & Mark IV; Contact:
Contact RodinKy

Location

Post by RodinKy » March 13th, 2017, 1:20 pm

The transmitter half has a recessed screw on the back labeled Plate Tuning, what does this do?

MDYoungblood Verified: Site Admin; Posts: 10,809; Joined: June 12th, 2010, 8:05 pm; Handle: MDYoungblood; Real Name: Gregory; Antenna: HyGain AV-6160; Radio: Icom IC-746 (non pro); Contact:
Contact MDYoungblood

Location Facebook

Post by MDYoungblood » March 13th, 2017, 2:49 pm

Look the radio up on CB Trick's, there are owners manuals for most Browning radios.

3's

Greg

"321, West Manchester Township, PA"

Official Moderator - CBRT Complaint Department

bluemeanie: Donor; Posts: 349; Joined: November 1st, 2012, 9:11 pm; Handle: Blue; Real Name: Mark Schwab; Antenna: Max 2000 MACO M105; Radio: LOTS OF TUBES; Contact:
Contact bluemeanie

Location Website

Post by bluemeanie » March 25th, 2017, 12:25 pm

It fine tunes the plate current. Select ma on the meter switch and adjust bias to middle of the indicator. If its close leave it alone. Blue

warlock35po: Duckplucker; Posts: 150; Joined: February 10th, 2010, 1:19 pm; Handle: Warlock35Po; Real Name: Don; Call Sign: VE1CSP; Antenna: Beam and/2 wave Dipole; Radio: Kenwood 570 D G; Contact:
Contact warlock35po

Location