anytone 6666 driving klv550

[lucky43113]

I have a brand new anytone 6666 and a klv550 amp. I was wondering why my radio will not drive the amp. The radio on low is dead keying 2watt swinging 5 watt on am. The amp will only do 50 watt. The amp works fine on my cobra 2000 that has more swing. I changed nothing except the radio.

[443 Arizona]

do you have a different mic to try? sounds like a "latching" relay isn't picking up ,
tell us what radio you are trying to use

[lucky43113]

do you have a different mic to try? sounds like a "latching" relay isn't picking up ,
tell us what radio you are trying to use

The radio doesn't have any swing so it won't trip the relay. Im just going to play it stock

[jessejamesdallas]

That amp needs about 15-20w peak input...not more than 20-25w

[443 Arizona]

no swing, no matter, you want to change voltage and that can be done 35 ways from well(you know)
so if you tell what radio and mic you are tying to adapt to, the solution comes closer.

[lucky43113]

no swing, no matter, you want to change voltage and that can be done 35 ways from well(you know)
so if you tell what radio and mic you are tying to adapt to, the solution comes closer.

I did tell what radio anytone 6666 all stock

[443 Arizona]

sorry for the overlooked info, i had to go back to the beginning to see what the radio was, i am getting old and its showing. i already forgot what this reply is about ,

[Blue Ox2]

Hey there 443,

You are sooooo right. Is it possible that you could have the exact specifications for this pushrod we discuss?
I am looking to develop a project for 3D printing.

Discussion of the dual push rod is possible, and if there are dimensions available for them as well.

This could turn into something big.

Hope to hear more from you soon.

Good luck with the antenna too. I hate it when they get hit like that. Keep those groundings buried deeply.

73,

Mike